TC Electronic D-TWO User Manual - page 16
18
DELAY MODES
Additional Effects
To the Straight Delay mode the effects described below
can be added:
Please see detailed description on the following pages.
Spatial:
Gives the Delay a wider feeling either by using left channel
offset or Phase Reverse of left, right or both channels.
Filter:
In a traditional feedback loop, the signal will pass the
feedback filter each time it passes through the feedback
loop. This is perceived as if the signal is gradually filtered
more and more, repeat after repeat. This effect can be
achieved in the Straight mode by using the FB filters.
Chorus:
Adds Chorus, to smooth the Delay repeats.
Dynamic:
A ducking function that reduces the Output level of the
Delay with a specified level when the Input signal
exceeds a certain Threshold.
PingPong:
The PingPong effect synchronizes panning with the
tempo of the Delay repeats.
Feedback #
Press and hold the FEEDBACK/RHYTHM key and dial
the DELAY wheel to change the exact number of Delay
repeats. The maximum number of repeats is 10 or limited
by the total Delay time. In case of limited repeats, the
FEEDBACK # parameter will be blinking.
E.g. 10 repeats of 1500ms = >10 seconds.
Shuffle
The Shuffle parameter allows you to add shuffle feel to
the straight Delay repeats. The shuffle feel is added to
every second repeat, by offsetting the repeat according to
the percentage of the shuffle parameter.
The Shuffle parameter only works on straight
Subdivisions i.e. 1/2, 1/4, 1/8, 1/16.
Quantize
The Quantize parameter has no effect in the Straight
mode.
Track tap
The Track tap parameter allows the preset to instantly
track the current basic tempo, and adapt to this, as
opposed to using the tempo that the current preset was
stored with.
This enables you to use a number of presets without hav-
ing to tap the overall tempo more than once.
RhythmDcay
The RhythmDcay parameter has no effect in the Straight
mode.
Subdivision
The Subdivision recalculates the basic Delay time
accordingly. BPM equals 1/4 subdivision.
Press and hold the DELAY/TAP key and dial the
DELAY wheel, to change the Subdivision.