TC Electronic D-TWO User Manual - page 22
24
ADDITIONAL ALGORITHMS
To each of the described Delay modes the following
effects can be added.
Spatial
Basic operation
Entering the Spatial menu can be done in two ways.
Press EDIT and scroll to the Spatial parameters.
Double click the SPATIAL key for shortcut.
The SPATIAL key also works as on/off for the Spatial
function.
Offset L
Range: +/-200ms
Offsets the Left channel by +/- 200ms. The Offset is always
added to the Main Delay time. The Offset is independent of
the Tap function.
Phase Reverse
Range: L, R L&R
With the Phase Reverse parameter you can reverse the
phase of the Delay left, Delay right or the entire Delay
signal.
Filter
Basic operation
Entering the Filter menu can be done in two ways.
Press EDIT and scroll to the Filter parameters.
Double click the FILTER key for shortcut.
The FILTER key also works as on/off for the Filter function.
FB High Cut - Feedback - High Cut
Range: 19.95Hz - 20kHz
High Cut type filter that allows you to reduce the high
frequencies of the Delay. This gives you a softer and more
analog sounding Delay which in some cases will seem less
disturbing on the overall sound, than a Delay with no
High Cut.
FB Low Cut - Feedback - Low Cut
Range: 19.95 - 20kHz
Low Cut type filter reducing the low end frequencies of the
Delay. When using Delay on signals with low frequencies a
full-range Delay might introduce a less tight feeling in that
area. Use the Low Cut filter to avoid this.
High Cut
Range: 19.95Hz - 20kHz
High Cut filter allowing reduction of the high end
frequencies on the source material.
Low Cut
Range: 19.95Hz - 20kHz
Low Cut filter allowing reduction of the low end
frequencies in the source material.
Chorus
Basic operation
Entering the Chorus menu can be done in two ways.
Press EDIT and scroll to the Chorus parameters.
Double click the CHORUS key for shortcut.
The CHORUS key also works as on/off for the Chorus
function.
Speed
Range: 0.05Hz - 19.95Hz
Sets the Speed of the Chorus.
Depth
Range: 0 - 100%
Sets the Depth of the Chorus.
Amount
Range: 0-100%
Sets the amount of Chorus added to the Delay signal.
Feedback
Range: -100 to +100
The amount of processed signal that is fed back to the
Input of the Chorus. When the feedback value is
negative, the Feedback signal is phase reversed. Use the
Feedback parameter to create a Flange effect.
Chorus Time
Range: 0 - 50ms
A Chorus is basically a Delay being pitch-modulated by an
LFO (Low Frequency Oscillator). The typical Delay time
used in a Chorus is around 10-20ms. A Flanger typically
uses a Delay time of approx. 5-10ms.