Therm-App Hz Operation Manual - page 3
Therm-App
®
Operation Manual
Document: D03101_05 Page 3 of 19
Safety and Caution Notes
Read this document in full, as well as the warranty document provided with the product.
Attach the Therm-App
®
Hz
device to your Android device with care.
Tighten the sizing knob until the Therm-App
®
Hz device is securely
attached to your Android device. Do not use tools, as applying too
much pressure might mark or damage the device.
To obtain accurate temperature measurements, wait a minimum of
three minutes after start-up to enable stabilization of the detector.
The Therm-App
®
Hz device uses specific factory-prepared
calibration data. If degraded performance is noted after a prolonged
field use, it can be sent to the Therm-App
®
lab for recalibration.
Please contact our support team at
support@therm-app.com
for
further instructions.
Use only the USB OTG cables provided with the Therm-App
®
Hz,
as using other types of cables could damage the Therm-App
®
Hz
device.
Power the Therm-App
®
Hz
device 5V DC using the micro USB
connector by connecting it to a smartphone or other USB host
connectors only. Using any other type of power source may
damage the Therm-App
®
Hz
device.
To avoid breakage, do not drop the Therm-App
®
Hz device or apply
pressure on the IR lens. If the IR lens breaks, do not touch the
broken pieces as it may cause injury.
Do not point the infrared detector (with or without the lens and lens
cover) at intensive energy sources (e.g. the sun, laser radiation or
open flames). This could damage the detector.
Do not use the Therm-App
®
Hz
device in temperatures higher than
+50 degrees Celsius (+122 degrees Fahrenheit). High temperatures
can cause damage to the detector.
The Therm-App
®
Hz
device is not water resistant sealed. As such,
do not expose the Therm-App
®
Hz
device to water, rain, or dust.
Do not apply solvents or similar liquids to the detector or the lens.
The lens has a delicate anti-reflective coating. Clean the lens using
only a soft cloth applying very light pressure.
Do not use pressurized air to remove dust from the Therm-App
®
Hz
device. Pressurized air contains oil mist intended to lubricate
pneumatic tools, which could damage the detector and lens.
Therm-App
®
Hz is a Class B digital product. This product has been tested and
found to comply with the limits for a Class B digital product, pursuant to Part 15
of the U.S. FCC Rules.