Therm-App Hz Operation Manual - page 8
Therm-App
®
Operation Manual
Document: D03101_05 Page 8 of 19
Set Up
Connecting Therm-App
®
Hz to the Android Device
A. Turn the sizing knob [1] opening the
clamps just enough so that the
Android device [3] slides into the
attachment bracket [2].
B. Attach Therm-App
®
Hz to the back of
the mobile device by turning the sizing
knob.
C. Tighten the sizing knob [1] and the
bracket [2] to fit the Android device.
Ensure that the device is firmly
attached.
Note:
Do not fasten the sizing knob too tightly
as it could damage the Android device.
D. Connect the USB-OTG cable to both
Therm-App
®
Hz [2] and mobile device [1].
Note:
Use only the USB-OTG cable supplied.
In most cases, the micro USB cables
supplied with mobile phones do not support
USB-OTG functionality.
Note:
Verify that the USB-OTG cable is
properly connected to the Therm-App
®
Hz
and the mobile device.
Note:
For the first use of the Therm-App
®
Hz device with an Android device, an
initialization process must be completed.
This process may take a few minutes and
must not be interrupted. Make sure you
have a stable internet connection prior to
connecting your mobile device to the
Therm-App
®
Hz device.