VADDIO AutoTrak 2.0 Installation And User Manual - Short Term Confidential
AutoTrak 2.0 Camera Tracking System
©2012 Vaddio - All Rights Reserved. AutoTrak 2.0 Camera Tracking System - Document Number 342-0382 Rev. A
Page 15 of 47
The AutoTrak 2.0 CPU, Camera and Software Operating Instructions
The AutoTrak 2.0 CPU is a 1-RU rack mount
computer that comes preloaded with the
AutoTrak 2.0 software. It is a closed system
based on a Linux operating system.
The AutoTrak 2.0 CPU uses an Intel® Atom™ Dual Core Processor, Intel Graphics Media Accelerator,
1GB DDR2 Memory with six (6) USB ports, four(4) RS-232 Ports, two (2) PS/2 interfaces for
keyboard/mouse, 16GB Compact Flash and Video capture card. CPU specifications and cosmetics are
subject to change.
Getting Started:
1) Take the AutoTrak 2.0 CPU out of the box to start the system connection.
2) Connect two (2) of the 998-1001-232 control adapters (check part numbers carefully) to serial com
ports 1 and 2. The IR Reference camera will be connected to Port 1 and the Tracking Camera will be
connected to Port 2.
3) Connect the Keyboard and the Mouse to the AutoTrak 2.0 CPU using USB ports
4) Connect the computer monitor (not included) to the DE-15 (HD-15) on the AutoTrak 2.0 CPU.
5) Connect the AC Power Cord, but do not turn on the computer yet.
Mounting the Cameras and Distance Limits:
The AutoTrak 2.0 systems are shipped with
either a dual HD-18 camera mount or an HD-18
and HD-20 Camera that can be mounted to a
wall permanently or be mounted to an optional
cart system. The vertically stacked camera
arrangement is required for the AutoTrak 2.0
software to track properly
.
Consider the placement of the cameras
carefully; the range of use is from 12’ (3.65m)
and up to 40’ (12.2m). System positioning is
critical for proper and consistent operation. If
the distance from the presenter to the wall
mounting location is greater than 40’ (12.2m),
then an optional portable cart system is
recommended to place the cameras in range of
the IR Lanyard, which is required for the tracking
system to acquire the IR LED light in order to
track the presenter.
Mount the cameras with the IR Reference
Camera on the top shelf of the dual mount and
mount the Tracking Camera on the lower shelf
of the dual mount.
Please mark and test the cables prior to termination. Please do not connect these
cameras up to the Quick-Connect systems using the “guess/trial and error” method.
AutoTrak 2.0
HD-18
IR Reference
Camera with
Adapters and
Filters
AutoTrak 2.0
HD-18
Tracking
Camera
Dual Mount
AutoTrak 2.0
HD-20
Tracking
Camera
AutoTrak 2.0
HD-18
IR Reference
Camera with
Adapters and
Filters
AutoTrak 2.0 999-7260-000
HD-18 IR Reference
Camera and HD-20
Tracking Camera
AutoTrak 2.0 999-7250-000
Dual HD-18 Cameras for
IR Reference and Tracking
Cameras
Dual Mount