VADDIO AutoTrak 2.0 Installation And User Manual - Short Term Confidential
AutoTrak 2.0 Camera Tracking System
©2012 Vaddio - All Rights Reserved. AutoTrak 2.0 Camera Tracking System - Document Number 342-0382 Rev. A
Page 33 of 47
enough capture data received to recognize the Lanyard.
Auto Gain
This value increases the IR Camera gain to recognize the lanyard. Default = 30,
Range 0 – 30
Pan Correction
This value, in degrees, overcorrects the Reference Camera target used to calculate
the Tracking Camera pan location when the configuration uses side by side cameras
(CONFIGURATION NOT RECOMMENDED).
Tilt Correction
This value, in degrees, overcorrects the Reference Camera target used to calculate
the Tracking camera tilt location. This parameter automatically adjusts the
Reference Tilt to compensate for the distance vertically between the cameras.
Tracking Zoom
Position
This value, in steps, directs the zoom setting of the tracking camera.
Setup Pan
Speed
This value, degrees’ is used in the ‘User Interface’ to set camera presets.
Setup Tilt
Speed
This value, degrees’ is used in the ‘User Interface’ to set camera presets.
AutoPresenter
Port
This string represents the Device name of the serial port used to communicate with
an AutoPresenter.
Reference
Camera Port
This string represents the Device name of the serial port used to communicate with
the IR Reference Camera.
Tracking
Camera Port
This string represents the Device name of the serial port used to communicate with
the Tracking Camera.
Iris Control
Ref. Camera
This parameter is used to reduce the light and increase the contrast of the lanyard
IR emitters. Default value is in parenthesis.
Iris Control
Tracking
Camera
This parameter is used to adjust the iris (f-stop) to prevent blooming between light
and dark areas in auto iris mode. The Default value is Auto mode, but if blooming
within the presenter area is a problem, switch to manual.
Camera Select
This parameter is used select either the AutoTrak 2.0 HD-18 or AutoTrak 2.0 HD-20
as the Tracking Camera (Iris values are different between cameras). Note: The HD-
18 is always the reference camera.
Auto Focus
Type
This parameter allows the user to select the Auto Focus method. The two (2)
options are; Low Light – works in average and even light conditions, Low and Bright
Light – works better in rooms with bright spots and reflections. Bright light
containing IR will hinder AutoTrak 2.0 operation.
Details on the Vaddio AutoTrak 2.0 HD-18 Pan/Tilt/Zoom Cameras used in the AutoTrak 2.0
System:
④
①
②
Camera Features:
1) Camera/Sensor/Optics:
1/3-Type, Megapixel HD CCD image sensor is
combined with an 18x optical zoom lens, for
capturing high-quality HD video.
2) Tally
Light:
A red tally light is illuminated when the camera
receives a VISCA command from an external
control system and tally is triggered.
3) IR
Sensors:
IR sensors are built into the front of the
WallVIEW HD-18 to receive IR signals from the
IR remote control supplied with the camera.
4) Power
Light:
A blue power light is illuminated when the
camera is turned on.