VADDIO AutoTrak 2.0 Installation And User Manual - Short Term Confidential
AutoTrak 2.0 Camera Tracking System
©2012 Vaddio - All Rights Reserved. AutoTrak 2.0 Camera Tracking System - Document Number 342-0382 Rev. A
Page 41 of 47
Part 15, Subpart C of the FCC Rules
and RS-210 of Industry Canada
. These limits are designed to
provide reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the interference at
his/her own expense.
Operation is subject to the following two conditions: (1) This device may not cause interference, and
(2) This device must accept any interference including interference that may cause undesired
operation of the device.
Changes or modifications not expressly approved by Vaddio can affect emission compliance and
could void the user’s authority to operate this equipment.
Do not use any antenna other than the one provided on the unit.
This equipment complies with the FCC/IC radiation exposure limits set forth for portable transmitting
devices operating in an uncontrolled environment. End users must follow the specific operating
instructions for satisfying RF exposure compliance
ICES-003 Compliance
ICES-003, Issue 4: 2004
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus
set out in the Radio Interference Regulations of the Canadian Department of Communications.
Le présent appareil numérique n’emet pas de bruits radioélectriques dépassant les limites applicables
aux appareils numeriques de la classe B préscrites dans le Règlement sur le brouillage radioélectrique
édicte par le ministère des Communications du Canada.
European Compliance
This product has been evaluated for Electromagnetic Compatibility under the EMC Directive for Emissions and
Immunity and meets the requirements for a Class A digital device. In a domestic environment this product may cause
radio interference in which case the user may be required to take adequate measures.
Standard(s) To Which Conformity Is Declared:
EMC Directive 2004/108/EC
EN 55022 A:
2006 + A1: 2007(CISPR 22:2005/A1:2005)
Conducted and Radiated Emissions
EN 55024:
1998 + Amendments A1: 2001 + A2: 2003
Immunity
EN 61000-4-2: 1995 + Amendments A1: 1998 + A2: 2001
Electrostatic Discharge
EN 61000-4-3: 2006 + A1: 2008
Radiated Immunity
EN 61000-4-4: 2004 + Corrigendum 2006
Test not applicable to this device.
EN 61000-4-5: 2006
Test not applicable to this device.
EN
61000-4-6:
2009
Test not applicable to this device.
EN
61000-4-8:
2010
Power
Frequency
Magnetic
Field
EN 61000-4-11: Second Edition: 2004
Test not applicable to this device.