Valor Fires 823 Installer And Owner Manual - Fitting The Light Diffuser.
Knightsbridge model.
The rear of the spacer has wider flanges. These should be to the rear when fitting.
1. Position the rear of the spacer frame against the wall. Ensure that the spacer frame
is central to the fireplace. It is important that the side legs are positioned correctly and
are upright.
2. Mark the upper positions of the key hole
slots on the rear wall (See figure 8).
3. Remove the spacer frame from the fireplace
and place away from the work area.
4. Drill the screw locations using a suitably
sized masonry drill bit for the wall plugs
supplied.
5. Insert two wall plugs provided into the
holes.
6. Insert a woodscrew into each hole and
screw in until there is approximately 6mm of
screw protruding from the wall.
Preparing the heater for installation.
1. Using the four No.8 x 3/8 screws provided, fix the
heater to the spacer frame.
2. There is a supply cable slot on both sides of the
spacer frame. It is located at the base. Decide which
side to pass the supply cable through and position the
supply cable in the spacer frame slot (See figure 9).
Fitting the heater.
1. Locate the spacer frame and heater over the screw heads ensuring a tight fit. If the
fit is loose, remove the spacer frame and heater from the wall. Tighten the wall
screws slightly and reposition the spacer frame and heater.
Fitting the light diffuser.
1. There is a light diffuser supplied
with the heater (See figure 10). Place
this on to the metal flange below the
plastic screen (See figure 10).
Page 12
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2008.
Figure 10. Diffuser location
Figure 9. Locating the cable
Figure 8. Location points