Valor Fires 823 Installer And Owner Manual - Method A - Screw Fixing.
Fitting the cable guide.
When fitting the cable guide please remember that the wider part of the cable guide
has to be fitted against the outer edge of the base (See figure 2- Item 1).
1. Gently pinch the sides of the cable guide (See figure 2 - Item 4) and push the
cable guide into the required rectangular slot.
2. Place the electrical cable into the guide and close the top of the cable guide.
If the electric cable is damaged, to avoid a hazard it must be replaced by a Valor
Fires authorised service agent, or similarly qualified person (See the front cover of
this guide for useful telephone numbers).
All external wiring between the heater and the electrical supply shall comply with
current IEE regulations. Extension leads should
not be used.
Fascia support brackets.
On Westminster, Willoughby, Luxor and
Knightsbridge models, as supplied the fascia
support brackets may be flat against the heater
body. Using a suitable tool or gloved hand bend
the brackets as in figure 3. Do not bend the
brackets on Blenheim, Churchill, Silverdale or
Seattle models.
Heater fixing.
All fixings supplied with the heater have been
identified in figure 1.
If fitting the heater into a fireplace or surround
opening, try the heater in the opening to ensure
that it will fit.
If fitting the heater onto a decorative hearth surface
such as marble or tile it is advisable to protect the
hearth surface. Do not drag the heater across the
surface of the hearth as this may scratch the hearth
surface.
Method A - Screw fixing.
Note - If fixing to marble it is recommended that
Method B - ‘Wire fixing’ is used. Drilling marble
without the correct tools and experience may result in the marble cracking.
1. Place the heater into the fireplace or surround opening. Make sure that the heater
is in the middle of the surround or fireplace.
2. There are two slotted holes in the top of the heater (See figure 4). Mark through
the slotted holes so that their position is clear when the heater is removed.
Page 9
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2008.
Figure 4. Slots for screw
fixing.
Figure 3. Fascia support brackets