Valor Fires 823 Installer And Owner Manual - Fitting The Fuel Effect.
INSTALLER AND OWNER GUIDE
Page 16
Fitting the Willoughby fascia.
1. The lower part of the fascia is held in place using two magnets.
The magnets should sit on the brackets as in figure 19. If the
magnets have moved during transit then place them as in figure
19.
2. Holding the lower part of the fascia away from the heater body,
hook the upper brackets on the rear of the fascia over the brackets
on the heater (See figure 11).
3. The fascia is supplied with three decorative trims. Where fitted,
remove any protective film from the surface of the trims. Locate
the trims as in figure 20. Locate the side trims first.
4. There are two hanging screws on the rear of the firefront.
Locate these into the slots as in figure 13. If required, the screws
can be adjusted, to aid installation.
Fitting the fuel effect.
Seattle, Silverdale, Blenheim and
Churchill models.
1. This model is supplied with a one piece
fuel effect. Remove the fuel effect from
its packaging and place it on top of the
fuel support.
Knightsbridge, Westminster, Willoughby
and Luxor models.
Important notes.
The coal pieces supplied are a natural
material. Occasionally it will be necessary
to reduce the size of the coal pieces. To
do this place them inside a plastic bag,
place on a suitable hard surface and tap
gently with a small hammer or similar tool.
The coals are for decorative purposes only. There is a choke risk to young
children. Make sure they cannot gain access to them.
1. Place the loose coals onto the fuel support (a glove is provided with the coal pack).
It is not necessary to use all the coal supplied.
©
Baxi Heating U.K. Limited 2008.
Figure 20. Fascia trims
Figure 19.