Valor Fires 823 Installer And Owner Manual - Fitting The Fascia
Fitting the Fascia
Before fitting the fascia complete the
last page of this guide.
Fitting the Knightsbridge fascia.
1. Hook the brackets on the rear of the fascia
over the brackets on the heater (See figure 11).
2. Secure the base of the fascia with two M4 x
25 screws (See figure 12).
3. The rear of the firefront has two screws that
locate into ‘keyhole’ brackets on the heater (See
figure 13).
4. Place the ash pan in position.
Fitting the Westminster fascia.
1. Hook the brackets on the rear of the fascia
over the brackets on the heater (See figure 11).
2. Secure the base of the fascia with two M4 x 25
screws (See figure 12).
3. The rear of the firefront has four hooks that
locate on to brackets on the fascia (See figure 14).
Fitting the Luxor fascia.
1. Unpack and remove the fascia from its
packaging.
2. The heater is supplied with a coal support
assembly (See figure 1). Locate this to the rear of
the fascia as in figure 15. Secure in place using
two M5 x 8 screws supplied.
3. Hook the brackets on the rear of the fascia over
the brackets on the heater (See
figure 11).
4. Secure the base of the fascia
with two M4 x 25 screws (See
figure 12).
5. Place the lower firefront
casting at the fascia base.
Page 13
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2008.
Figure 13. Fitting the firefront.(Fascia may differ
from that shown).
Figure 12. Securing the fascia.
(Fascia may differ from that
shown)
Figure 11. Fitting the facia. The
fascia may differ from that shown.