Valor Fires 823 Installer And Owner Manual - One Side of The Heater.
1. My heater is on but there is no light or the light appears brighter on
one side of the heater.
This is possibly a lamp failure. Remove the lamp(s) as follows and check it / them in a
table lamp that is known to work. If it / they do not work in the table lamp then replace
as below.
The lamps fitted to the heater are:
Westminster, Knightsbridge, Willoughby and Luxor models -
Standard clear 40W max. E14 candle lamps.
Blenheim, Churchill, Silverdale and Seattle models -
7W SES E14 compact fluorescent lamps.
Due to indeterminate life span and ease of replacement, lamps are specifically
excluded from the guarantee. Please note that either type of lamps specified above
can be used as replacements, but we recommend, for visual appearance, that only
lamps of the same specification are used in a single heater.
To remove and replace the lamp(s).
1. To gain access to the lamp/s, remove the
coal / pebble fuel effect from the fuel support
and place onto an old newspaper or plastic
bag. This will prevent surface marking.
2. Remove the firefront.
3. Unscrew and remove the copper reflector
plate (See figure 23).
4. Replace the lamp/s (See figure 24).
5. Refit the copper reflector plate. Refit the
firefront / fascia and coal / pebble.
2. My heater is on but there is no
light or heat.
The first thing to do is check the wall
socket. To do this plug in a known working
appliance. If the appliance you have
plugged in works then there is a good
chance that the problem lies with the 13
Amp fuse in the heater plug. If either fuse or
socket is suspected, have them checked by
an electrician.
Page 19
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2008.
Figure 23. Copper reflector
Figure 24. Bulb replacement