Valor Fires 823 Installer And Owner Manual - 1. Handling And Unpacking
1. HANDLING AND UNPACKING
Before continuing any further with the installation of this heater please read the
following:
Unpacking.
The Knightsbridge, Westminster and Luxor heaters have fascias that are heavy.
To avoid damage, they are packed in a separate box within the main box.
Important safety instructions.
The approximate lifting weights (kg) of the heater parts are listed below:
Heater
Heat engine
Complete Fascia
Spacer
Fuel effect
Knightsbridge
5.5
11.13
1.3
1.0
Westminster
5.5
8.2
1.3
1.0
Luxor
5.5
13.8
1.3
1.0
Blenheim
5.5
4.58
N/A*
0.7
Churchill
5.5
4.58
N/A*
0.7
Seattle
5.5
0.91
N/A*
0.9
Silverdale
5.5
0.91
N/A*
0.9
Willoughby
5.5
5.3
1.3
1.0
* An optional spacer frame kit is obtainable either from your heater supplier or direct
from Valor Fires Sales. The kit is a 75mm (3 inch) spacer kit (Kit number 05801T1).
One person should be sufficient to lift the heater. If for any reason this weight is
considered too heavy then obtain assistance.
When lifting always keep your back straight. Bend your legs and not your back.
Avoid twisting at the waist. It is better to reposition your feet.
Avoid upper body/top heavy bending. Always bend from the knees rather than the
waist. Do not lean forward or sideways whilst handling the heater.
Always grip with the palm of the hand. Do not use the tips of fingers for support.
Always keep the heater as close to the body as possible. This will minimise the
cantilever action.
Use gloves to provide additional grip.
Always use assistance if required.
2. SAFETY
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Page 4
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2008.