Valor Fires 823 Installer And Owner Manual - 4. Using The Heater
4. USING THE HEATER
Important Safety
Never cover the heater or obstruct the opening at the base of the heater, this
could cause overheating and consequent risk of fire.
The appliance can be controlled by the manual control located on
the upper left hand side of the heater or by using the remote
control handset.
Remote Control - What do the buttons do?
Pressing the red ‘ON/OFF’ button.
To activate the remote handset it is necessary to press the red
ON/OFF button (See figure 21). The ‘On’ lamp on the heater will
turn red - see figure 22).
Pressing the ‘LAMP’ button.
This turns the effect on. The ‘On’ lamp will no longer be visible and
the status lamp will flash green for approximately five seconds,
after this time the lamp will no longer be visible.
Pressing the ‘Heat 1’ button.
This turns the effect and 1 kW heater on. The ‘On’ lamp will no
longer be visible and the status lamp will flash amber for
approximately five seconds, after this time the lamp will no longer be visible.
Pressing the ‘Heat 2’ button.
This turns the effect and 2 kW heater on. The
‘On’ lamp will no longer be visible and the
status lamp will flash red for approximately five
seconds, after this time the lamp will no longer
be visible.
Pressing the red ‘ON/OFF’ button.
Pressing this button at any time whilst the
effect and heater are in operation will turn the
effect and heater off. The red ‘On’ lamp will no
longer be visible.
Page 17
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2008.
Figure 21.
Figure 22.