Valor Legend 937XN Installation And Owner's Manual - page 12
12
12.5
Place the two front logs in position on the front rail of the
firebox. It may be necessary to raise the center log slightly
in order to fit the left-hand front log. Make sure that
there is a gap of approximately ¼” between the front right
stump of the center log and the cut-out section at the rear
of the right front log. See figure 15.
13.
CONTROLS OPERATION CHECK
13.1
Refit the control cover panel. Refit the two control knobs
13.2
If installed with a pedestal base, refit the pedestal front
panel.
13.3
If installed with a traditional design front fascia, fit the
window frame top cover (supplied in the pack) over the
top of the window frame to hide the bare metal (see figure
16).
13.4
Refit the window (with top cover if applicable).
•
Hook the top of the window frame over the firebox
top front edge.
•
Swing the window down over the bottom center
locating stud.
•
Secure the window unit in place by refitting the
knurled nut and two knurled screws at the sides and
bottom of the window frame.
•
Check ignition, gas control valve and thermostat
settings as described in the lighting instructions
section further on in this manual.
Fig. 16 Window top cover
Fig.15 Front Log position