Valor Legend 937XN Installation And Owner's Manual - page 6
6
5.
PACK CONTENTS
The complete appliance is contained in two packs. One of the
alternative base support and front designs will be included - either
pedestal with contemporary fascia or Legs with traditional fascia
(See pack 2).
Pack 1 - Main appliance unit contains:-
1
Main appliance fitted with window.
4
Ceramic logs.
1
Pair ceramic firebox side walls.
1
Ceramic firebox back wall.
1
Decorative vent collar for appliance top.
1
Gas supply inlet pipe.
1
Gas supply inlet elbow.
1
Exhaust port cover
Pack 2 - Pedestal and contemporary fascia alternative
contains:-
1
Pedestal unit.
1
Contemporary design front fascia unit.
1
Ashlip unit.
4
#8 tapping screws (for fixing ashlip).
4
Machine screws (for fixing pedestal to main appliance).
2
Wood screws (for floor fixing).
2
Plugs (for floor fixing).
or
Pack 2 - Legs and traditional fascia alternative contains:-
1
Base & legs unit.
1
Traditional design front fascia unit.
1
Door retaining bracket.
1
Window frame top cover.
2
#10 tapping screws (for door retaining bracket).
4
Machine screws (for fixing base & leg unit to main
appliance).
2
Wood screws (for floor fixing).
2
Plugs (for floor fixing).
Take care when removing the contents from the packaging to
prevent damage. Check that all the contents are in the packs and
are undamaged.
6.
APPLIANCE PREPARATION
6.1
Remove the window & logs (see figure 2)
6.1.1
Detach the window unit by removing the two knurled
screws (“A”)and knurled nut (“B”) holding the sides and
bottom of the window frame.
6.1.2
Lift the window unit up and forwards to unhook the top.
Put the window in a safe place.
6.1.3
Take the ceramic logs out of the firebox and store safely.
6.2
Check ignition electrode spark (see figure 3)
The pilot burner and electrode are at the right side of the
firebox.
Open the control access door. Turn the gas control knob
(the right hand knob) counterclockwise to “Ign”. While
turning pilot ignition sparks should be activated twice.
Check that the sparks are produced at the pilot burner.
If no sparks are produced, check that the wiring is secure
and that the spark gap is 3.5 + 0.5 mm.
Fig. 2 Window removal
Fig. 3 Pilot ignition system