Valor Legend 937XN Installation And Owner's Manual - page 9
9
8.2.9
Replace the door as follows:
8.2.9.1
Locate the hinge pin at top of the door into the hole at
the top of the door aperture (see figure 8).
8.2.9.2
Locate the hinge pin at bottom of the door into the slot
in the base. Swing the bottom of the door part way to
the back. A new door-retaining bracket is supplied with
the leg and fascia kit. Hold this bracket under the
bottom of the base side. Position it with the two holes at
the bottom and locate the single hole over the bottom
door hinge pin (see figure 8).
8.2.9.3
While keeping the bracket located to the hinge pin,
swing the door and bracket fully backwards. Align the
two holes in the bracket with the two holes in the base
side and fix with the two tapping screws provided (see
figure 8).
9.
VENT CONNECTION
Connect an approved 4” vent unit to the appliance vent collar.
A decorative vent collar is supplied with the appliance to cover the
vent and appliance collar joint at the top of the heater.
LOCATE TOP DOOR HINGE PIN
LOCATE BOTTOM HINGE PIN IN SLOT & SWING
DOOR PART WAY TO BACK
FIT BRACKET TO HINGE PIN & SWING BACK
SECURE BRACKET WITH 2 SCREWS
Fig. 8 Door fitting with leg design base