Valor Legend 937XN Installation And Owner's Manual - page 8
8
8.
BASE & MAIN APPLIANCE INSTALLATION
8.1
PEDESTAL BASE
8.1.1
Detach the pedestal front panel by removing two screws.
8.1.2
Place the pedestal in position (see figure 5). The bottom
rear of the pedestal must be at least 2½” from the back wall
to maintain the 2” rear clearance shown in figure 1.
8.1.3
Mark the floor with the floor fixing positions through the
holes in the pedestal (see figure 5).
8.1.4
Remove the pedestal. Drill the floor at the marked
positions and fit plugs if necessary.
8.1.5
For easier fixing, fit the two woodscrews supplied into the
floor partially leaving a space between the screw heads and
the floor. The pedestal has two “keyhole” openings in its
bottom channels. Place the pedestal back in position by
dropping it to locate the screws in the wide holes of the
keyholes and then sliding the pedestal back to locate the
screws in the narrow slots of the keyholes. Tighten the
screws.
8.1.6
Fit the inlet elbow to the supply pipe.
Note: If the optional circulating fan kit is intended to be installed,
it will be easiest to fit it at this stage
8.1.7
Place the main appliance unit over the pedestal, align the 4
fixing holes (2 at each side) and secure the unit to the
pedestal with 4 machine screws.
8.2
BASE WITH LEGS
8.2.1
Detach the door retaining bracket (located near the rear
right corner of the appliance main unit) by removing two
screws (see figure 6).
8.2.2.
Swing the bottom of the door forward to release the
bottom pin from the slot in the case and lift the door clear
(see figure 6).
8.2.3
Place the base in position (see figure 7). The rear of the
base must be at least 2” away from the rear wall to allow
air flow to the installed appliance.
8
.2.4
Mark the floor fixing positions through the holes in the
rear feet.
8.2.5
Remove the base. Drill the floor at the marked positions
and fit plugs if necessary.
8.2.6
Replace the base. Fit woodscrews through the rear feet and
tighten.
8.2.7
Fit the inlet elbow to the supply pipe.
8.2.8
Place the main appliance unit over the base, align the
securing holes (see figure 7). Secure with 4 machine
screws.
Fig. 5 Pedestal positioning
REMOVE BRACKET
SWING DOOR FORWARD
Fig. 6 Door removal
Fig.7 Leg base positioning