Waldorf BP8080G Installation And Operation Manual - page 20
18
Cleaning and Maintenance
General
Clean the bratt pan regularly. A clean bratt pan looks better, will last longer and will perform better.
A dirty bratt pan will hinder the transfer of heat from the cooking surface to the food. This will result
in loss of cooking efficiency.
NOTE:
DO NOT clean appliance using high pressure water or steam jets.
DO NOT pour water directly over appliance.
DO NOT use wire brushes. Clean pan regularly after each use.
DO NOT use combustible liquids to clean appliance.
DO NOT use harsh abrasive detergents, sharp scrapers, strong solvents or caustic
detergents as they will damage appliance.
DO NOT use any chloric or bleaching detergents to clean appliance.
DO NOT use saline or sulfuric acid preparations for descaling appliance.
Ensure that protective gloves are worn during cleaning process.
Clean pan regularly after each use.
After Each Use
Clean interior of pan regularly after each use. Do not use wire brushes on the pan. Clean using a mild
detergent and a hot water solution using soft cloth or a soft bristled brush. Dry appliance thoroughly using
a dry clean cloth.
Clean exterior of bratt pan using a mild detergent and a hot water solution using soft cloth or a soft bristled
brush.
Daily Cleaning
Clean bratt pan control panel using a soft cloth moistened with a solution of mild detergent and hot water.
DO NOT USE EXCESSIVE WATER. Dry control panel thoroughly using a dry clean cloth.
Clean interior and exterior of bratt pan using a mild detergent and a hot water solution using soft cloth or a
soft bristled brush. Do not use wire brushes on the pan. Dry appliance thoroughly using a dry clean cloth.
Clean control panel with a damp cloth lightly moistened with a solution of mild detergent and water. Wipe
dry with a clean dry cloth.
Always turn ‘Off’ the electrical and gas supply before cleaning.
This appliance is not water proof.
Do not use water jet spray to clean interior or exterior of this appliance.
Caution
If cleaning detergents are allowed to enter the inner parts of appliance, rusting
will occur on pipe work, installation elements, heating elements, gas fittings
and electrical components, this will cause premature failure of the appliance.
Caution