Waldorf BP8080G Installation And Operation Manual - page 7

5 

Specifications

Gas Connection 

Gas supply connection point is located at rear of appliance, approximately 60mm from left hand side, 

305mm from rear, 125mm from floor and is reached from beneath appliance.  (Refer to ‘Dimensions’ 

section). 

Connection is ¾" BSP male thread. 

Electrical Supply Requirements 

Electrical supply connection point is located at rear of appliance, approximately 74mm from left hand 

side, 574mm from rear of appliance and 290mm from floor. 

BP8080G / BP8120G - 

220-240V a.c, 50 / 60Hz, 0.1kW, 1P+N+E. 

BP8080GE /BP8120GE - 

220-240V a.c, 50 / 60Hz, 0.35kW, 1P+N+E. 

Water Supply Requirements 

Cold water connection is 

1

/

2

" tube connection via 15mm crox fitting located 280mm from LH side, 574mm 

from rear and 240mm from floor. 

Water supply must be protected by an 'In-Line' sediment filter / strainer, which should be fitted into  

pipeline prior to Bratt Pan water connection. 

Maximum water supply pressure 550kPa (80psi). 

Maximum water inlet temperature - 80°C.