Summary of DMLS60-3V LP
Page 1
1 design certified crossfire systems hmls60-24v lp/ng dmls60-3v lp/ng mls60 lp/ng.
Page 2: 1) General Info
2 improper installation, adjustment, alteration, service, or maintenance can cause injury or property damage. Read the installation, operating, and maintenance instructions thoroughly before installing or servicing this equipment. Warning: •do not store or use gasoline or other flammable vapors and ...
Page 3
3 the steps listed as: warnings: contains information critical to the safe installation and operation of the fire-pit. Warranty requirement: must be strictly followed to qualify for product warranty. Warranty will be void if not followed. Important: are notes and insights to help ensure product sati...
Page 4: 2) Location
4 2) location warning: for electronic ignition models there must be an electrical shut off ( wall switch or breaker ) on the exterior of the fireplace or on adjacent wall to allow for emergency shutdown and maintenance. Warning: all fireplaces must have a gas shutoff on the outside of the exterior o...
Page 5: 4) Fireplace Installation
5 least two opposing sides (2 vents total) at a minimum size of 18 sq. Inches each (example: 3”x 6” or larger). Installation of the vents in the mid to lower area of the enclosure is recommended. Ventilation allows for heat and or residual fuel to escape. Failure to properly vent enclosure may resul...
Page 6
6 installer to test for gas leaks at all connections. Warning: when filling the pan with lava rock and/or decorative glass, the instructions in section 5 must be followed. Warning: gas plumbing connections: use only joint compound or tape that is resistant to all gases. Apply joint compound to all m...
Page 7: 5) Media
7 5) media warning: for glass media usage with lp gas- when using approved decorative glass to cover burner apply only enough to hide burner. Applying over 1/2” may create back pressure and gas leakage from air mixer resulting in lp pooling under fireplace. Warning: for glass media usage with lp gas...
Page 8
8 for electronic ignition 3) pilot assembly screen: do not cover pilot assemble screen or opening with lava rock or glass. Incorrect media installation will cause the pilot flame to suffocate and turn off pit or delay main burner ignition. Optional – placing fire logs 4) place approved logs on top o...
Page 9: 6) Parts List
9 the pilot flame to suffocate and turn off pit or delay main burner ignition. Do not cover pilot screen! Do not cover pilot opening! 6) parts list 1. Fireplace and/or mls60 and electronic control systems • crossfire burner (cfb60) • aluminum plate (alp) • honeywell electronic ignition system (24vik...
Page 10
10 42rfp 42” round fireplace 4830rfp 48” x 30” rectangle fireplace 42rbf red brick schoolhouse – 42” fireplace holly60 hollyhock sculptural fireplace sbgh-l solid black granite hearth fireplace sbgh-r solid light granite hearth fireplace tail60 the tailgater portable copper fireplace tail-pc60 the t...
Page 11: 7) Installation
11 hemi 26 26” hemi fire bowl hemi 36 36” hemi fire bowl firebox 30 30” firebox firetable fire table firetrough fire trough note: all models may contain one of the burners listed in the table below: 60k btu/h burner model number description hmls60-*ng honeywell, natural gas hmls60-*lp honeywell, pro...
Page 12: 8) Fireplace Operation
12 8) fireplace operation warning: if you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury, or loss of life. Warning: if using an lp bottle, position at safe distance away from flame. Warning: do not place lp bottle inside enclosure. W...
Page 13
13 b. If you do not smell gas, proceed to next step. 4. Turn key valve slowly clockwise to the on position (fig. 2) while igniting lighter simultaneously to ignite gas. (fig. 1) turn key valve (fig. 2) light while turning key valve check for good flame and gas leaks add media and repeat warning: if ...
Page 14: 9) Maintenance
14 1. Turn key valve counterclockwise until it stops. 2. Carefully verify flame is out. 3. After cooling, cover fireplace with vinyl cover. 9) maintenance warning: any guard or protective device removed for servicing must be replaced prior to operating the fireplace. Warning: installation and repair...
Page 15: 11) Warranty
15 below are some potential causes and countermeasures to the symptoms indicated in bold. Please contact your retailer or certified technician for service & repair. No pilot flame (hot wire glows) 1. Air in gas line. If new install, may take several attempts to purge air 2. Debris in gas line. Confi...
Page 16
16 system tags and markings.
Page 17
17.
Page 18
18.
Page 19
19.