WarmingTends DMLS60-3V LP Instruction Manual - 8) Fireplace Operation
12
8) Fireplace Operation
Warning: If you do not follow these instructions exactly, a fire or
explosion may result causing property damage, personal
injury, or loss of life.
Warning: If using an LP bottle, position at safe distance away from
flame.
Warning: Do not place LP bottle inside enclosure.
Warning: Use only your hand to turn the gas key valve. Never use
tools. If the key valve will not turn by hand, don’t try to repair it. Call a
qualified technician. Force or attempted repair may cause a fire or
explosion.
Warning: Before use, be sure to test all gas connections for leaks.
Do not use Fireplace if there is any evidence of leaking gas. If leaking
gas suspected, turn off the main gas supply and repair.
Warning: Wind and gusty conditions will affect the flame in an
unpredictable manner. If conditions exist that are not safe for patrons
turn the Fireplace off.
Warning: Do not use Fireplace if any part has been submerged
under water. Immediately call a qualified service technician to inspect
the Fireplace.
Warning: Never use any material that is non-porous and holds
moisture such as gravel, pebbles, river rock, etc. This material, when
heated will cause the trapped moisture to boil and fracture unexpectedly.
This material is not sufficiently porous to allow heated steam to readily
escape which can break and cause personal injury or damage.
Warning:
Solid fuels shall not be burned in the Fireplace. Leaves,
sticks, wood, paper, clothing, food material, should be kept away from
the Fireplace. Make sure that there is no vegetation or other objects over
the top or sides of the Fireplace that could interfere with safe operation.
See clearances in section 2 Selecting the Location.
Warning: If lava rock is wet, allow Fireplace to burn for 45 minutes
prior to coming within 15 feet of the Fireplace.
Warning: When Fireplace is not in operation turn off gas valve.
WARRANTY REQUIREMENT: When not in use the Fireplace must be
covered at all times.
IMPORTANT: Initial Start-up: It may be necessary to purge air in gas
lines after system installation.
MANUAL LIGHTING INSTRUCTIONS
1. STOP! Read the safety information above.
2. Turn key valve (Fig. 1) slightly and turn counterclockwise to the OFF
position.
3. Wait (5) minutes to clear out any gas. Then smell for gas.
a. If you smell gas, STOP! See front page- “What to do if smell gas”
section.