WaterRower M1 SERIES Owner's Manual - page 7
12
13
STEP 1
Remove the M1 rails from their box(es) and lay them on the floor. Remove the
M1 rear end pad assembly (with bungee connected) from the tank/component
box. Carefully slide the two M1 rear end pad bracket ends into the M1 rails.
The metal legs protruding from the M1 end cap fit inside the tubular section of
the rails.
STEP 2
Use the Ratchet supplied, four button head cap screws and four washers to
fasten the M1 rear end pad assembly to the M1 rails as shown.
STEP 3
Remove the seat assembly from the tank/component box and place it on/
between the rails with the indent facing towards the rear end pad. The
larger vertically mounted wheels (the load wheels) should sit on the plastic
extrusions on top of the rail. The smaller horizontal wheels below the seat
(the guide wheels) should sit between the rails. It may be necessary to
separate the rails slightly to allow the guide wheels to fit down between
the rails.
STEP 4
Remove the M1 tank assembly from the tank/component box. Carefully slide
the M1 tank assembly onto the M1 rails as shown. The metal legs protruding
from the M1 end cap fit inside the tubular section of the rails, as they did with
the M1 rear end pad assembly.
STEP 5
Use the Ratchet supplied, four button head cap screws and four washers to
fasten the M1 front end pad assembly to the M1 rails as shown, as they did
with the M1 rear end pad assembly.
STEP 6
Use the included syphon pump (or a hose if available) to fill the tank to the
desired level with municipal water.
Do not overfill your WaterRower. Anything beyond Level 19 (the maximum
level) may risk leaking and void the warranty.
Use blue dye OR the purification tablet (provided). Do not use both. Additional
purification tablets are available upon request at:
www.waterrowerservice.com/puritabs
Once completed, insert the Tank
Stopper; it may be necessary to moisten
the Stopper to assist with replacement.
►
Please wipe excess water from tank
after filling.