WaterRower M1 SERIES Owner's Manual - page 8

14

15

WATER LEVEL - 

The Level Gauge is positioned on the side of the tank. Information 

on the sticker includes WaterRower contact information and the Water Level 

Gauge. The maximum level to fill the tank is Level 19. DO NOT fill above the 

maximum level - this could void the warranty. The standard Calibration Level is 

Level 17.

STEP 7

Remove the M1 tank assembly cover from the tank/component box. Starting 

just behind the monitor, position the cover at an angle. Slide it down and 

across so it covers the clutch and recoil mechanism area. Gently fit the front 

edge into the supporting and protective shims. 

Note: The access panel on the left side of the cover allows for easier access to 

the tank stopper once the cover is in place.

SHIMS

ACCESS PANEL

STEP 8

Remove the M1 footboard assembly from the tank/component box. 

Carefully slide the M1 footboard assembly between the M1 rails, as 

shown.

STEP 9

Use the Ratchet supplied, two button head cap screws, two 

footboard spacers (attached to footboard) and two washers to fasten 

the M1 footboard assembly to the M1 rails, as shown. It is important 

that the spacers are positioned between rails and the footboard.

RAIL

FOOTBOARD

SPACER 

(

attached to footboard)

WASHER

BUTTON HEAD

CAP SCREWS