WATT AGE Fokker Dr.1 Assembly Instructions Manual - page 11
Page
❑
Cuttwohingeslotsintheleadingedgeoftherudder,equallyspaced
betweenthetopandbottom,thenslidethehingesintoplace,usingthesame
techniquesthatyoudidtoinstallthehingesintheelevator.
IMPORTANTAswiththeelevator,makesuretocutthehingeslotson
thecenterlineoftheleadingedge.
❑
Cutthecorrespondinghingeslotsinthebackofthefuselage,thenhinge
theruddertothefuselage,usingthesametechniquesthatyouusedtohinge
theelevatortothestabilizer.
❑
AfterallowingtheC/Atocompletelycure,gentlypullontheelevatorandruddertochecktheintegrityofthehinges.Thehinges
shouldholdsecurely.Ifoneormorehingesisloose,applymoreC/Atothehinge(s).
you'll neeD the FolloWing pArts From the kit:
eleVAtor AnD ruDDer Control systems instAllAtion
you'll neeD the FolloWing tools AnD supplies:
❑
KwikBondThinC/A
❑
#1PhillipsHeadScrewdriver
❑
WireCutters
❑
(2) CarbonFiberPushrods(Long)
❑
(2) PrebentWireswithZ-Bends
❑
(2) Heat-ShrinkTubing
❑
ModelingKnife
❑
ElectricorHandDrillwith1/16"(1.6mm)DrillBit
❑
HeatGun
step 1: instAlling the eleVAtor AnD ruDDer serVos
❑
Installtheelevatorandrudderservosintotheservotray,makingsureto
drill1/16"(1.6mm)diameterpilotholesforthemountingscrews.
IMPORTANT Installtheservossothattheoutputshaftsaretowardthe
backofthefuselage.
☞
Dependingonthesizeofyourservos,youmayneedtoenlargethe
servomountingholes.
step 2: instAlling the eleVAtor linkAge Assembly
❑
Cutawayallbutonearmfromaservohorn,thenattachonepushrodinto
the
outermost holeintheservoarm.