WATT AGE Fokker Dr.1 Assembly Instructions Manual - page 21
Page
step 1: instAlling the Wing tip skiDs
❑
Cutawaythecoveringmaterialfromoverthewingtipskidmountingslots
in the bottom of the bottom wing, then fit and glue the two wing tip skids into
place.
step 2: instAlling the eleCtroniC speeD Control
❑
IfyourESCfeaturesanon/offswitch,mountitinaconvenientplaceon
thesideofthefuselage.
❑
Mount your ESC to the fuselage side, directly behind the firewall, using
apieceofdouble-sidedfoamtape(notincluded).
PRO TIPDependingonthelengthofyourESCsbatterywires,youmay
wanttosolderlongerwiresintoplacetomakeiteasiertopluginand
unplugyourbattery.
❑
PlugtheservoandESCleadsintotheirproperslotsinyourreceiver,then
mount your receiver to bottom of the cockpit floor, underneath the servos,
usingapieceofdouble-sidedfoamtape(notincluded).
❑
Runtheantennaoutthebottomofthecockpitandsecureitalongthe
bottomofthefuselage,usingpiecesofcleartape(notincluded).
Do not
cut the antenna shorter. Allow the excess to hang beyond the back of
the fuselage.
❑
JointhetwoaileronservoleadsusingaY-harnessandpushtheexcesswiresupintothewingthroughtheservoleadexitholes.
Useacoupleofpiecesofcleartape(notincluded)tosecuretheaileronservoleadtothecabanestrutwhereitentersthecockpit.
step 3: instAlling the reCeiVer
❑
Tomakeiteasiertoinstallandremovethebattery,makeahandleoutof
a length of strapping tape (or other type of strong tape) and firmly adhere it
toyourbattery.
step 4: instAlling the bAttery
❑
Mount the battery to the fuselage floor, directly behind the firewall, using
apieceofhookandloopmaterial(notincluded).