WATT AGE Fokker Dr.1 Assembly Instructions Manual - page 20
Page 0
IMPORTANT Before installing the two outer wing struts in the
nextprocedure,makesurethatyouinstallthemsothattheyareangled
backward toward the trailing edge and that mounting tab with the
"ASCENDING"labelisgluedintothetopwing.
❑
Cutawaythecoveringmaterialfromovertheouterwingstrutmounting
slots in the bottom of the wing, then fit and glue the two outer wing struts
intothemountingslots.
step 3: instAlling the top Wing
❑
Double-checkthealignmentofthewings.Whenviewedfromthefront,allthreewingsshouldbelevelwitheachother.Check
thestabilizer,too.Itshouldbelevelwiththewings.Ifit'snot,loosenthemountingscrewsandinstallathinshimunderthelowside
andretightenthescrews.Next,checkthewingsfromthetop.Theyshouldallbeparallelwitheachotherandstraight.
❑
Setthewingontothefuselageandpushthemountingtabintheouter
wingstrutsintothewingstrutmountingslotsinthecenterwing.
IMPORTANTAswiththetwolowerouterwingstruts,don'tgluethe
upper outer wing struts to the center wing or it will be impossible to
remove the wing if you need to. The outer wing struts fit into the center
wingwithoutusingglue.
❑
Securethecabanestrutstothefrontmountingbrackets,usingtwo
M2x6mmmachinescrewsandtwoM2hexnuts.
IMPORTANTMountthecabanestrutstotheoutsideofthemounting
brackets.
❑
Securethecabanestrutstotherearmountingbrackets,usingtwo
M2x6mmmachinescrewsandtwoM2hexnuts.
IMPORTANTMountthecabanestrutstotheoutsideofthemounting
brackets.
you'll neeD the FolloWing pArts From the kit:
FinAl Assembly
you'll neeD the FolloWing tools AnD supplies:
❑
KwikBondThickC/A
❑
AdjustableWrench
❑
ExcelModelingKnife
❑
Scissors
❑
(2) PlywoodWingTipSkids
❑
(1) DecalSet
❑
K&S30WattSolderingIron
❑
Solder
❑
Heat-ShrinkTubing(AssortedSizes)