WATT AGE Fokker Dr.1 Assembly Instructions Manual - page 16
Page
step 2: instAlling the Center Wing
❑
Cutawaythecoveringmaterialfromoverthetopandbottomofthe
wing-screwmountingholesinthecenterwing,thencutawaythecovering
materialfromovertheouterwingstrutmountingslotsinboththetopand
thebottomofthewing.
❑
ApplyacoupleofdropsofthinC/Aintothecenterwingmountingholes
inthefuselageandletitdrycompletely.
IMPORTANTThereareatotaloffourouterwingstrutsincluded.Forthisstep,makesurethatyouareusingthetwothatare
labeled"DOWN".Theseareforthebottomwing."DOWN"islaseredonthelowermountingtab.
Beforeinstallingthetwoouterwingstrutsinthenextprocedure,makesurethatyouinstallthemsothattheyareangled
forward
andthatmountingtabwiththe"DOWN"labelisgluedintothebottomwing.
❑
Fitandgluethetwoouterwingstrutsintothemountingslotsinthetop
ofthebottomwing.
IMPORTANTAgain,makesurethatyouinstalltheouterwingstrutsso
thattheyareangledforwardandthatthemountingtabwiththe"DOWN"
labelisgluedintothewing.
IMPORTANTInthenexttwoprocedures,you'llinstallthecenterwing.Do not gluetheouterwingstrutstothecenterwing.
If you do, it will be impossible to remove either the bottom wing or the center wing from the fuselage. The outer wing struts fit into
thecenterwingwithoutusingglue.
❑
Gently flex the ends of the bottom wing down, then push the mounting
tabintheouterwingstrutsintothewingstrutmountingslotsinthebottom
ofthecenterwing.
☞
Again,donotgluetheouterwingstrutstothecenterwing.
❑
Mountthecenterwingtothefuselage,usingtheremainingtwoM3x25mm
machinescrews.
IMPORTANTBecarefulnottoovertightenthemachinescrews.The
screwsneedonlybetightenedsnugly.