WATT AGE Fokker Dr.1 Assembly Instructions Manual - page 7
Page
❑
KwikBond5MinuteEpoxy
❑
KwikBondThinC/A
❑
#0and#2PhillipsHeadScrewdrivers
❑
ExcelModelingKnife
❑
ElectricorHandDrill
❑
1/16"(1.6mm)and1/8"(3.1mm)DrillBits
❑
Ruler
❑
(1) Fuselage
❑
(1) Cowling
❑
(1) MotorMountStick
❑
(1) PlywoodMotorMountPlate
❑
(3) M2x8mmWoodScrews
❑
Pencil
❑
MaskingTape
❑
PaperTowels
❑
RubbingAlcohol
❑
NHPEpoxyMixingSticks
❑
NHPEpoxyMixingCups
you'll neeD the FolloWing pArts From the kit:
motor AnD CoWling instAllAtion
you'll neeD the FolloWing tools AnD supplies:
step 1A: instAlling the motor - kms brushless outrunner or similAr
❑
Usingthescribelinesontheplywoodmotormountplate,positionand
drillholesthroughthemotormountplatetoinstallyourmotor.
❑
Installyourmotorontotheplywoodmotormountplate,usingthescrews
providedwithyourmotor.
IMPORTANTUsepanheadscrewstoinstallyourmotor,sothatwhen
tightened, they'll be flush with the surface of the motor mount plate. This
willpreventthescrewheadsfrominterferingwiththeinstallationofthe
motor assembly onto the firewall.
❑
Glue the motor mount plate to the firewall, making sure that the radius
alongthetopofthemotormountplatematchestheradiusalongthetopof
the cutout in the firewall.
PRO TIPDependingonthelengthofthemotorwires,youmightwantto
connectyourESCnow,beforeinstallingthemotor.Ifthemotorwiresare
too short, it can be difficult to reach them through the cockpit later.
step 1b: instAlling the motor - brusheD stiCk mount motor
❑
Carefullycutoutthethreemountingsquaresandthecirclethatareetched
on the firewall. A sharp modeling knife works well for this.