Weal Union TI-810+ User Manual - 2.3.15 Pga370S Cpu Socket
TI-810+ Motherboard
Page 10
2.3.15 PGA370S CPU Socket
The motherboard provides a ZIF Socket 370. The CPU that comes with the
motherboard should have a fan attached to it to prevent overheating. If it is not so,
purchase a fan before you turn on your system.
Notice!!! Be sure that there is a sufficient air circulation across the processor
’
s
heatsink by regularly checking that your CPU fan is working. Without sufficient
circulation, the processor could be overheated and it may damage both the processor
and the motherboard. You may install an auxiliary fan, if necessary.
Installation step:
1. Turn off the power of your system and remove its cover;
2. Locate the ZIF socket and open it by first pulling the lever sideways away from
the socket then upwards to a 90-degree angle;
3. Insert the CPU with correct orientation
(The CPU has a corner pin for two of the four corners, that the CPU only fit in the
orientation.)
4. Once completely inserted, pull down the socket
’
s lever to horizontal and make
sure the CPU is firmly locked in the socket.
2.3.16 CPU Fan Connector
CPU Fan cable plug in the 3-pin CPU Fan connector onboard.
Pin1
Sense
Pin2
+12V
Pin3
GND
2.3.17 Audio Connector
(Available for TI-810+ES and TI-810+S model only)
This connector supports the optional connector set for audio input/output and
game/MIDI port. The connector set connects to the 26-pin block and mounts to an
open slot on your computer
’
s chassis.
Note: This connector is available only on motherboard with optional onboard audio
support. The AT motherboard provides Audio header for Audio Cable and Audio
connectors:
Line Input
Microphone Input
Line Output
Game/MIDI Port (15Pins)
2
1
26
25
Audio Connector (onboard)