Weal Union TI-810+ User Manual - 2.3.7 Sdram Sockets
TI-810+ Motherboard
Page 8
EXPANSION CARDS INSTALLATION
Before adding or removing any expansion cards or system components, confirm
that you already unplugged your power supply. Otherwise, it may severely
damage to your motherboard and expansion cards. Please follow the installation
procedures as below:
1. Check carefully if those hardware or software settings for your expansion cards
are in the proper position as shown in their User
’
s Manual.
2. Remove your computer case
’
s cover and unscrew the bracket plate for those
slots needed to insert.
3. Those expansion cards must be aligned on the slots firmly with good connection.
4. Put on the computer case cover.
5. If needed, set up the BIOS configuration and install the required drivers for your
expansion cards.
2.3.7 SDRAM Sockets
There are two SDRAM sockets on-board to provide more flexibility for your system
memory upgrade. Because the number of pins are different on either side of the
breaks, the DIMM module will only fit the 3.3V 168-pin unbuffered for this motherboard.
168-Pin SDRAM Module Installation Diagram
2.3.8 Floppy Drive Connector (34-Pin)
This connector supports the provided floppy drive ribbon cable. After connecting
the single end to the on-board
“
FLOPPY
”
connector, connect the remaining
plugs on the other end to the floppy drives correspondingly.
2.3.9 IDE Connectors (40-Pin)
The IDE connectors support the provided IDE HDD ribbon cable. After connecting
the single end to the board, connect the two plugs at the other end to your HDDs.
3 . 3 V K e y
U n b u f f e r e d
D R A M K e y
2 0 P in s
6 0 P in s
8 8 P in s
L o c k
T w o D I M M S o c k e t