Weal Union TI-810+ User Manual - 2.3.10 Bios
Page 9
TI-810+ Motherboard
If you install two IDE devices on the same cable, you must configure the second
device to slave mode by setting its jumper accordingly. (Refer to your IDE device
document for the jumper settings. Pin 20 is removed to prevent inserting in the
wrong orientation when using ribbon cables with pin 20 plugged.)
IDE Connectors
2.3.10 BIOS
The motherboard flash BIOS provides users with more flexibility in upgrading their
motherboards. The flash BIOS can be easily reprogrammed via software.
2.3.11 PCI Slots
This motherboard provides four full-length 32-bit PCI slots with up to 133MB/sec
burst data transfer rate.
2.3.12 AMR Slot
This connector supports a specially designed audio and/or modem card called an
AMR.
2.3.13 Front Panel Function Connector
The front panel integrates: 2-pin Power On, 2-pin IDE LED, 5-pin Keylock, 2-pin
Reset Switch, 2-pin Sleep, 2-pin ExtSMI, 4-pin Speaker.
The connector pin out are described as the figure below:
1 ATXPWRON
2
Reset Con
3
Ground
4
Ground
5
VCC
6
SLEEP
7
IDE LED
8
Ground
1 0 ExtSMI
1 1
PWR LED
1 2 Ground
1 3
Ground
1 4 Speaker
1 5
Ground
1 6 Ground
1 7
Key Lock
1 8 Ground
1 9
Ground
2 0 VCC +5V
2.3.14 Wake-On-LAN Interface
This connector connects to a LAN card with a Wake-On-LAN output. The connec-
tor powers up the system when a wakeup signal is received from the network.
Pin1
Primary IDE (IDE1)
Secondary IDE (IDE2)
Pin20 be removed
PWR ON
IDE LED
KEYLOCK
RESET
SLEEP
EXTSMI
SPEAKER