Weal Union TI-810+ User Manual - page 6
TI-810+ Motherboard
Page 6
2.3 Function & Installation Instructions
2.3.1 AT Power Supply Connector (12-Pin)
This connector connects to a standard 5V power supply. To connect the leads from
the power supply, ensure first that the power supply is not power on. Most power
supplies provide two plugs, and each plug contains six wires. Two of six wires are
black and please orient the plugs to the connector so that 4 black wires are together.
AT Power Connector
At a slight angle, align the plastic guide pins on the lead to their receptacles on
the connector. Once aligned, press the lead onto the connector until the lead locks
into place.
2.3.2 ATX Power Supply Connector (20-Pin)
This connector connects to an ATX power supply. The plug from ATX power
supply will only insert in one orientation because of the different hole sizes. Find
the proper orientation and push down firmly making sure that the pins are aligned.
The system power can be turned off through software control, like the shut down
in Windows 2000 / ME / 98 / 95 start menu. Power management must be enabled in
the system BIOS in order to activate this soft-off feature. Once the system BIOS
receives the power management command from the OS, it will switch the system
power off.
ATX Power Connector
PG
+5V
+12V
-12V
Ground
-5V
+5V
Red
White
Black
Blue
Y
ellow
Red
Orange
Power Plug
Power Plug
Power Plugs
from Power
Supply
Power
Connector on
Motherboard
+3.3V
-12V
Ground
PW_ON
Ground
Ground
Ground
-5V
+5V
+5V
Power Connector
on Motherboard
+3.3V
+3.3V
Ground
+5V
Ground
+5V
Ground
PWRGOOD
+5VSB
+12V