Weal Union TI-810+ User Manual - 2.3.19 Vga Connector
Page 11
TI-810+ Motherboard
2.3.18 Internal Audio Connectors(CD, AUX, 4-pin Modem)
These connectors allow you to receive stereo audio input from such sound sources
as a CD-ROM, MPEG card. The Modem connector allows the onboard audio to
interface with an voice modem card with a similar connector. It also allows the
sharing of mono_in (such as a phone) and mono_out(such as a speaker) between
the onboard audio and the voice modem card.
Telephony Input 1
(1: Mono_in; 2,3: Ground; 4: Mono_out)
CD Input 1
(1,3: Ground; 2: Right Audio Channel; 4: Left Audio Channel)
Auxiliary Input 1
(1: Left Audio Channel; 2, 3: Ground; 4: Right Audio Channel)
CD Input
(1: Left Audio Channel; 2, 3: Ground; 4: Right Audio Channel)
2.3.19 VGA Connector
The VGA connector allows you to connect a standard monitor through the
provided VGA cable with mounting bracket. Connect the cable to this header and
mount the bracket to the case on a free expansion slot.
1
Chapter 3
Software Installation
Note:
Before installation, you must already have Windows 95/98/2000/ME
or Windows NT4.0 install on your computer.
The installation procedure is as below:
1. Make sure that Auto-insert detection is enabled for your CDROM drive.
It should be enabled by default.
2. Insert this CD disk into your CDROM drive.
3. The Explorer screen will then appear, that gives you instructions for
installation.
4. There may require restarts of Windows during some software setup. In
these cases, you can just eject then close the CD-tray in order to get
back to the Explorer screen. You can then proceed with the next step.
You can get more information with open file: readme.txt in the CD disk.