Webasto Diesel Cooker x100 Installation Instructions Manual - Webasto Diesel Cooker X100
8 / ENGLISH
Webasto Diesel Cooker X100
The fuel couplings must be properly tightened to prevent any air
leaks into the hose. Air will cause malfunction of the cooker.
Always check that the coupling surfaces of the fuel hose and the fuel
hose itself are clean before tightening them.
Figure 9:
Set the ventilation box
around the cooker under the
table. Measurements for the
ventilation box installation
are in figure 4. Fasten only
the ventilation box to the
tabletop with 10 pcs 3.9 mm
screws. Leave the fuel hose
and power cable inside the
ventilation box.
Figure 10:
Take off the front plate of the
ventilation box. Fasten the
exhaust tube ø 28 mm and
cooling air outlet ø 60 mm
with hose clamps.
Figure 9:
Figure 10:
Figure 11:
Figure 11:
Connect the cooling fan to
the control unit board
(connector J13). Ensure that
the grooves of the
connectors are aligned.