Webasto Diesel Cooker x100 Installation Instructions Manual - Webasto Diesel Cooker X100
11 / ENGLISH
Webasto Diesel Cooker X100
4 Fuel supply
The fuel couplings must be properly tightened to prevent any air
leaks into the hose. Air will cause malfunction of the unit.
Always check that the coupling surfaces of the fuel hose and the
fuel hose itself are clean before tightening them.
The fuel must not be taken from the fuel hose going to the engine.
The maximum allowed pressure for cooker fuel hose is 2 bar.
Figure 17:
A) Fuel pickup from the plastic
tank via tank fitting. The fitting
must be made from metal.
4.1 Fuel line
The maximum length of the
fuel hose is 8 m. The fuel
hose shall always be cut to
suitable length for each
installation.
The fuel hose must always
be equipped with a filter. The
fuel filter shall be installed
inside the vehicle to prevent
freezing in winter. Use a
place where it can be easily
checked and replaced if
necessary.
4.2 Fuel feed
The fuel tank must always be
situated below the cooker.
The delivery lift of the fuel
pump should be less than
1.5 m.
If the delivery height of the
fuel pump is above 1.5 m,
the fuel feeding needs to be
checked and adjusted if
necessary. The fuel feeding
must also be checked
whenever a fuel system part,
such as the pump or
electronics card, has been
replaced.
Fuel feed adjustment must
be carried out by an
authorized service provider.
4.3 Fuel connection
Cut Mecanyl lines without
burr and do not crush them.
Do not cut them with side-
cutting pliers.
A rubber hose suitable to
diesel must be used with all
fuel connections.
4.3.1 Fuel extractor
Figure 17.
The fuel can be taken from
the vehicle fuel tank or from
a separate tank with fuel
extractor.
B) Fuel pickup from the plastic
tank via tank drain screw.