Webasto Diesel Cooker x100 Installation Instructions Manual - Webasto Diesel Cooker X100
15 / ENGLISH
Webasto Diesel Cooker X100
7 Initial start-up
The cooker starts to heat up
automatically when the
power switch is turned to ON
position. The yellow indicator
lamp lights up as soon as
the cooker is switched on.
The red combustion lamp
will light up when a proper
combustion has stabilized in
the burner, which is 2.5-4
minutes after the start-up.
The cooker will not
necessarily start the first
try after installation when
the fuel hose is empty. Then
the red combustion light
starts to blink about 4.5
minutes after the start-up.
Turn the power switch to
OFF position. The device
cannot be restarted until both
indicator lamps have gone
out (run down phase).
Once the indicator lamps
have gone out, restart the
stove. The red combustion
lamp will light up about 2.5-4
minutes after the start-up,
when the combustion is
normal.
The cooker locks itself after two unsuccessful starts.
If the device will not start, even though the fuel has reached the pump, do
not try to start it more than twice without checking the cause of the
problem.
If the fuel line does not fill up
during two starts, the cooker
will lock itself and both red
and yellow lights begin to
blink.
Unlocking the diesel cooker:
1. Switch the power ON (lock
blinking).
2. Disconnect the main
power cord (blinking stops).
3. Reconnect the main
power cord (the yellow LED
lights up for 1-3 seconds).
4. When the yellow LED has
gone out, switch the power
OFF.
5. Start cooker normally.
Turn the power switch to
OFF position to shut down
the stove after test use. The
red combustion lamp will
keep blinking for about 5
minutes while the cooker is
cooling.