Webasto Diesel Cooker x100 Installation Instructions Manual - Webasto Diesel Cooker X100
14 / ENGLISH
Webasto Diesel Cooker X100
6 Exhaust system
6.1 Exhaust outlet
Air must always be able to
flow free past the exhaust
gas outlet. Try to install the
outlet in such a way that
wind can blow past it. The
outlet must not be placed in
a corner or a confined area
when wind pressure may
disturb the operation of the
device.
6.2 Exhaust
installation
Make a ø 65 mm lead-
through to the floor for
exhaust gas and cooling air
tubes. Lead both tubes
through the hole. Let the
cooling air tube stick out
min. 10 mm below the
vehicles floor. Seal the floor
lead-through and cooling air
tube with heat resistance
silicone. Fasten the exhaust
gas tube under the vehicle.
Also fix the coaxial hose to
the furniture and the floor of
the vehicle. Exhaust gas and
cooling air tubes must
always run downwards to
avoid water traps. The
minimum bending radius for
the exhaust tube is 50 mm.
Exhaust gas is hot. Always make sure that there is no inflammable
material within 200 mm after the exhaust outlet.
Coaxial tube radiates heat. Beware of the hot surface of the tube
during use.
Figure 21:
The end of the exhaust gas tube shall point downwards with a
tolerance of
±10°. Make sure that the exhaust outlet ends at the side
of the vehicle opposite from the passanger entry door. Also ensure
that exhaust gas is blown away from underneath the vehicle.