Weber Motor MPE 850 Service Manual - page 28
28
SHB MPE850 Rev 1.2 | 408014 | 408090 | 408101 |
4 Operation
4.4 Service after driving
4.4 Service after driving
4.4.1 Flushing sea water cooling circuit
Damage in exhaust system caused by deposits.
If the sea water cooling circuit is not flushed regularly after driving,
sediments appear. Particularly within the cooling jacket of exhaust system.
►
Flush the sea water cooling circuit after each drive in salt water.
►
Take the vehicle out of water.
A 13 mm [1/2“] connection
1
for the flushing
device is installed at the engine. The flushing
device is attached at this connection.
►
Connect the flushing device. (See the
vehicle manufacturer‘s documentation.)
NOTICE! Engine damage due to water in the
engine. When the engine is switched off, the
water may get into the engine through the exhaust
system. First start the engine and then open the
water tap.
NOTICE! Engine damage caused by overheating.
Operate the engine without supply of water only at
idle and only for a maximum period of 30 seconds.
►
Start the engine and run the engine at idle.
►
Open the water tap.
The sea water cooling circuit will be flushed.
Weber Motor recommends to flush the sea
water cooling circuit at least for 5 minutes.
►
Close the water tap.
►
Switch off the engine.
►
Remove the flushing device.
Information!
Regularly use a cleansing concentrate to flush the sea water cooling circuit. Consult
your local vehicle dealer.
1