Weber Motor MPE 850 Service Manual - page 76
76
SHB MPE850 Rev 1.2 | 408014 | 408090 | 408101 |
6
7
Filling with coolant
►
Fill coolant to the expansion tank until the
MAX-marking
6
.
►
Close the expansion tank.
►
Warm up the engine. (See the vehicle
manufacturer‘s documentation.)
►
Check the coolant level.
CAUTION! Scalding caused by hot steam. Open
expansion tank only with a cold engine.
NOTICE! Danger of overheating caused by a lack
of coolant.
►
When coolant level is below the MIN-
marking
7
, wait until the engine has
cooled down.
►
Refill coolant, until the coolant level is
between the MIN-marking and the MAX-
marking.
NOTICE! Leaks in the hoses due to increased
pressure.
►
When the MAX-marking is exceeded, pump
out excessive coolant with a suction pump.
►
Touch up the paintwork defects.
►
Clear the service counter to reset service
light. (See the Weber Diagnostic Tool
manual.)
►
Update the engine control unit calibration.
(See the Weber Diagnostic Tool manual.)
►
Test-drive the vehicle.
8 Service tasks in the workshop
8.11 Changing coolant