Weber Motor MPE 850 Service Manual - page 67
Manual is about: 4-Stroke Engine MPE 850 MARINE
of
86
67
SHB MPE850 Rev 1.2 | 408014 | 408090 | 408101 |
14
16
15
15
2
1
1
8 Service tasks in the workshop
8.8 Replacing rubber mount
►
Close the hose clamp
14
.
Tightening torque:
3 Nm +0,5 Nm [2.2 lbf ft +0.4 lbf ft]
►
Insert the hose
16
.
Observe the marking.
►
Close the spring band clamps
15
.
►
Touch up the paintwork defects.
►
Clear the service counter to reset service
light. (See the Weber Diagnostic Tool
manual.)
►
Update the engine control unit calibration.
(See the Weber Diagnostic Tool manual.)
►
Switch on the ignition for a minute.
The throttle body is calibrated.
►
Test-drive the vehicle.
Engine variant I2 846 MAR TC-155
Remove the rubber mount with a cold engine.
►
Open the hose clamps
1
.
►
Remove the connecting pipe
2
.