Weber Motor MPE 850 Service Manual - page 32
32
SHB MPE850 Rev 1.2 | 408014 | 408090 | 408101 |
6 Malfunctions
6.1 Malfunctions table
6 Malfunctions
If you cannot correct a malfunction yourself using the malfunctions table below, contact a workshop
authorized by Weber Motor or the vehicle manufacturer immediately.
Malfunction
Possible cause
Remedy
The engine warning light
(MIL) is flashing.
There is an emission-related
malfunction.
Contact immediately a workshop
authorized by Weber Motor or the
vehicle manufacturer.
The engine warning light
(MIL) is illuminating.
There is a malfunction.
The engine warning light
(MIL) does not illuminate
after engine start.
The engine warning light comes
on after starting the engine for a
few seconds. If the (MIL) engine
warning light is not on, an error has
occurred.
The temperature warning
light is flashing or
illuminating.
Too high engine temperature.
The oil pressure light is on.
The oil pressure light comes on after
starting the engine until the required
oil pressure has built up. If the oil
pressure light does not go out, an
error has occurred.
Do not start the engine. Contact
immediately a workshop authorized
by Weber Motor or the vehicle
manufacturer.
The service light is
illuminating.
There is no malfunction. Service
tasks must be performed.
The service tasks must be
performed in a workshop authorized
by Weber Motor or the vehicle
manufacturer.
6.1 Malfunctions table