Workrite ES2E5472EOC Assembly & Installation Manual - ✓
Workrite Ergonomics | (800) 959–9675 www.workriteergo.com
11 of 12
Put Workcenter Upright and Connect Power Cord to the Power Supply
Turn the workcenter over into an upright position.
Plug the Power Cord (L) into the power outlet.
Initialize Legs
After all legs and the switch are connected, and the power cord has been plugged in, hold the
down arrow on
the switch until the legs make a short motion down and then back up. This initializes and synchronizes the
workcenter legs.
Adjust Feet Glides
If necessary, adjust leveling glides on the feet to level the worksurface. Unscrew to increase height, screw in to
decrease height.
Cleaning instructions
To clean the Essentia legs, apply cleaner to a soft cloth.
Suggested cleaners: Windex or Formula 409.
Do not use solvents and do not saturate or spray cleaners directly to workcenter base.
You must complete this
initialization step or your
workcenter will NOT
function properly.
Hold down the down arrow
until workcenter moves
slightly upwards!
Replacement Parts
Visit
http://workriteergo.com/documentation/other/workrite_ergonomics_pricing_specification_guide.pdf
for
replacement parts.
L
a
b
12
✓
13
14
b
a