Workrite ES2E5472EOC Assembly & Installation Manual - page 6
6 of 12
Workrite Ergonomics | (800) 959–9675 www.workriteergo.com
Attach Base to Pre-Drilled Workrite Worksurface
If you have a non-Workrite worksurface, skip to Step 6
Position leg assembly to align mounting holes in brackets to pre-drilled holes in worksurface.
Attach at the six corner locations using #12×¾" Pan Head Laminate Top Screws (I). If you use an electric
screwdriver, be sure it is on the lowest torque setting to avoid stripping the holes in the top.
With frame set positioned and the six corner screws secure, attach the frame set using the remaining using
#12×¾" Pan Head Laminate Top Screws (I).
Tighten securely.
Skip to
Step 7.
5
a
a
a
a
b
2 screws per
End Bracket
(2 installed in step 6c)
3 screws per
Short Bracket
1 screw per
Center Bracket
(2 installed in step 5b)
18 screws per
Connected Rear Bracket
12 screws per
Floating Rear Bracket
c
c
c
c
c
c
I
I
I
I
I
I
b
b
b
b
b
b
I
#12 × ¾" Pan Head
Laminate Top Screw
Hardware at actual size