Workrite ES2E5472EOC Assembly & Installation Manual - page 3
Workrite Ergonomics | (800) 959–9675 www.workriteergo.com
3 of 12
Layout Legs and Brackets
Check your cartons against the list
on page 1 to verify that you have all
the parts needed.
Place Legs (A) and Brackets (B, C, E
and F) on the floor.
Assemble Connected Rear Bracket Set
Assemble Rear Brackets (B) to Connector Bracket (C) using #M6 ×
10 mm Flat Head Cap Screws (D).
Use this guide to determine the correct holes for mounting
based on the width of your workcenter.
Tighten securely.
61"
55"
49"
43"
D
#M6 × 12 mm Flat Head
Cap Screw
B
E
E
E
B
C
C
B
H
1
Use with 52"×23"
or 58"×29" widths
Use with 58"×23"
or 64"×29" widths
2
To avoid stripping the threads, always
insert and make the first few turns
of the screw BY HAND with an Allen
wrench (J), ensuring it is in straight.
Use with 64"×23"
or 70"×29" widths
Use with 70"×23"
or 76"×29" widths
A
F
G
A
A
B
D
D
D
D
C
C
C
C
B
B
B
B
B
B
B
J
Hardware at actual size
Note!
Only use the #M6 × 12 mm Flat
Head Cap Screw (D) for assembly.