Workrite ES2E5472EOC Assembly & Installation Manual - page 8
8 of 12
Workrite Ergonomics | (800) 959–9675 www.workriteergo.com
Attach Control Box & Cable Spools to Worksurface
Position Control Box (M).
If you have a Workrite worksurface:
Locate the two pilot holes for the Control Box and proceed to
Step 8b.
If you do not have a Workrite worksurface:
Place Control Box (M) in position and use a pencil to mark pilot hole placement. Control Box should be placed
towards rear center of worksurface as shown. Remove Control Box and drill pilot holes where marked.
Do not
drill all the way through tabletop!
With Control Box (M) positioned over pilot holes, attach with two #12 × ¾" Pan Head Screws (I).
Attach Cable Spool (N) with the #12 × ¾" Pan Head Screw (I) to underside of worksurface. If you do not have a
Workrite worksurface, mount Cable Spools (N) in a convenient location between legs and control box. Lay out
Leg Cables (A) to be sure they all reach the Control Box.
Attach Feet (sold separately)
Refer to foot kit instructions for steps to install your
outside feet.
Attach Center Foot (U) to bottom of center leg (G) with
Flat Head Cap Screw (V) Using Allen Wrench (M) and
tighten securely.
L
a
b
c
K
8
7
N
N
M
A
A
A
N
I
I
I
I
I
L
#M6 × 16 mm Flat
Head Cap Screw
I
#12 × ¾" Pan Head
Laminate Top Screw
Hardware at actual size
Hardware at actual size
Note!
Only use the #M6 × 16 mm Flat Head
Cap Screw (L) supplied with Corner
Foot and Foot Kit for assembly.