Workrite ES2E5472EOC Assembly & Installation Manual - page 4
Manual is about: Essentia 3-Leg Workcenter
of
12
4 of 12
Workrite Ergonomics | (800) 959–9675 www.workriteergo.com
Assemble Floating Rear Bracket Set
Assemble Rear Brackets (B) to Connector Bracket (C) using #M6 ×
10 mm Flat Head Cap Screws (D).
Use this guide to determine the correct holes for mounting
based on the width of your workcenter.
Tighten securely.
43"
37"
34"
To avoid stripping the threads, always
insert and make the first few turns
of the screw BY HAND with an Allen
wrench (J), ensuring it is in straight.
Hardware at actual size
Use with 58"×29"
52"×29", or
52"×23"widths
Use with 64"× 29"
or 58"×23" widths
Use with 70"× 23",
70"×29" or
64"×23" widths
3
D
D
D
C
C
C
B
B
B
J
D
#M6 × 12 mm Flat Head
Cap Screw
Note!
Only use the #M6 × 12 mm Flat Head
Cap Screw (D) for assembly.