Workrite ES2E5472EOC Assembly & Installation Manual - page 7
Workrite Ergonomics | (800) 959–9675 www.workriteergo.com
7 of 12
Attach Base to Worksurface - Non-
Workrite Tops
Position Leg Assembly 2.875" from the sides
and 6.125" from the front of the worksurface,
making sure it runs parallel to the back edge
of the worksurface.
Use ⅛" drill bit to drill pilot holes at the six
corner locations. You may wish to mark your drill
bit so you do not drill any more than ¾" deep
and damage your worksurface top.
Do not drill all the way through worksurface!
Attach at the six corner locations using #12 × ¾" Pan Head Laminate Top Screws (I). If you use an electric
screwdriver, be sure it is on the lowest torque setting to avoid stripping the holes in the top.
With frame set positioned and the four corner screws secure, drill pilot holes first then attach the frame set using
the remaining #12×¾" Pan Head Laminate Top Screws (I).
Tighten securely.
>¾"
6.125"
23"– 30"
23"– 30"
2.875"
6.125"
2.875"
Parallel t
o edg
e
Parallel t
o edg
e
a
a
a
b
b
b
b
b
b
b
Note: Avoid trip or tip hazards!
For uniquely shaped, non-standard worksurfaces, it is the installers
responsibility to position the worksurface to minimize extended
overhangs and position feet fully under the worksurface.
6
2 screws per
End Bracket
(2 installed in step 6c)
3 screws per
Short Bracket
1 screw per
Center Bracket
(2 installed in step 6c)
18 screws per
Connected Rear Bracket
12 screws per
Floating Rear Bracket
I
I
I
I
I
I
I
#12 × ¾" Pan Head
Laminate Top Screw
Hardware at actual size
c
c
c
c
c
c
c
d
d
d
d
d
d