Workrite ES2E5472EOC Assembly & Installation Manual - page 5
Workrite Ergonomics | (800) 959–9675 www.workriteergo.com
5 of 12
Attach Short & Medium Brackets
Attach Short Brackets (E) using #M6×12 mm Flat Head Cap Screws
(D) to both legs.
Attach Right End Bracket (G) to sides of the Right Leg (A) using Flat Cap Screws (D). Attach Left End Bracket (F) to
sides of the Left Leg (A) using Flat Cap Screws (D). Attach Center Bracket (H) to the Center Leg (A) using Flat Cap
Screw (D).
Attach both the Connected Rear Bracket (B & C assembled) and Floating Rear Bracket (B) using Flat Cap Screws
(D).
Make sure the Connected Side Bracket is on the longer of the two sides.
Tighten securely.
Note: The right bracket will be on your left and vice
versa when the assembly is seen upside down.
Note: Left configurations will assemble as a mirror
images of these instructions.
Left configuration
Left Leg
Center Leg
Right Leg
Three piece
Connected Rear Bracket
B
&
C
assembled
Floating Rear
Bracket
B
&
C
a
b
c
To avoid stripping the threads, always
insert and make the first few turns
of the screw BY HAND with an Allen
wrench (J), ensuring it is in straight.
4
Right Bracket
Left Bracket
E
D
D
D
D
D
J
D
D
D
D
E
E
H
A
A
F
G
A
Hardware at actual size
D
#M6 × 12 mm Flat Head
Cap Screw
Caution!
Only use the #M6 × 12 mm Flat Head
Cap Screw (D) for assembly. Use of
longer screws will damage legs.