Xblue Networks X16 Installation Manual - page 20
X16 Inst
allation Guide
- 20 -
Endpoint Device
Step 2 – Ins
ert the Expansion
Module
Remove the plastic tab found on the front of the Voice server. Insert the
RJ14
(RJ48 for VoIP) connections
through the front
of the voice server and secur
e
the
card with the provided screws
. Connect the ribbon cable from the expansion
module to the main board and replace
the cover. Place the provided black
plastic encasement window around the newl
y installed card.
Endpoint Device
Every live telephone jack connected to th
e system will receiv
e a data signal. If
the system find
s an open jack
(bridge tap) the data signal m
a
y be lost, causing
the remaining
digital telephone endpoints to receive erroneous data, which may
lead to improp
er operation. Therefore,
for proper operation
each live telephone
jack, connected to the system, must have either a digital telephone end
point or
an endpoint de
vice.
Symptoms of an open jack inc
lude – but
not l
imited to - voic
e distortion
, st
atic
and slow speakerphone reaction when the b
u
tton is pressed, problems accessing
CO Lines, etc.
-
45 -
System Se
tup
System Setup
When System Setup is selected, the password will need to be
entered. At default, the password is ####.
The def
a
ult sys
tem password is
,
and can b
e
cha
n
ged to any 4
digit number.
To set the syst
em date and ti
me:
Enter the Year
in two digit year and the
n pres
s
the center navi
gation button. Enter the month
and the d
a
y in
four digit format and the
n
pr
ess
the center navi
gation button. Enter the hour
and the minute
s in 12 hour for
m
at, and then
press the cente
r navigation button. Press the up
navigation butt
on for P (PM) a
n
d the down
navigation butt
on for A (AM).
Note:
Caller ID
will maintain the time and dat
e
after it is set the
first time.
Recall time – When a call is
placed on hold, this
timer begins. When this timer expires, the call
placed on hold, will begin ringing all extensions
in the system.
Using the up or down navigati
on
key, the timer can be adjustable from 30, 45,
60, 90, and 12
0 seconds.
Tone/Pulse – This allows the system to be us
ed
on older network (Telephone
Company) Line
s.
DTMF (Touch
Tone) Tones ar
e used on most
network (Telephone Company
) lines.
Flash – The
Flash, which is a momentary
closure, is a rudimentary indication to the
telephone company line that
a feature is bei
n
g
enabled, such
as call waiting. This timer is
adjustable from 80 to 800 milliseconds.
AUTO MU
TE
Change
Pas
s
word
AUTO MU
TE
Date &
Tim
e
AUTO MU
TE
Recall Tim
e
=30 Sec
ond
s
AUTO MU
TE
Tone/Pu
lse
=Tone
AUTO MU
TE
Flash T
ime
=600 ms